Install the firmware

Flash the swing-up controller onto the ESP32-S3 from your browser.

You need an ESP32-S3 board with 16 MB flash and 8 MB PSRAM (N16R8, such as the ESP32-S3-DevKitC-1), a USB cable that carries data, and Chrome or Edge on a desktop. The rig it drives is described in the hardware notes.

  1. Plug in the board

    Connect the ESP32-S3 to your computer with the USB cable, to the port marked UART.

  2. Install the firmware

    Click the button, pick the board in the list your browser shows, then choose Install and confirm. It takes about a minute; keep this tab open and the board plugged in.

    This browser has no Web Serial. Use Chrome or Edge on a desktop. Web Serial needs HTTPS.

    Board not in the list? Hold BOOT, tap RESET, release BOOT, and click again. Your saved Wi-Fi network is kept. Skip Erase User Data in the install window: it also wipes the model.

  3. Install the model

    The firmware and the model are separate files, so install the model the same way: click, pick the board again (it restarted after step 2), then choose Install.

    Prefer the board's dashboard? Download the model (.ncpm) and drag it onto the dashboard instead.

  4. Connect it to Wi-Fi

    A new board opens its own network, cartpole-XXXX. Join it, open http://192.168.4.1 and enter your 2.4 GHz network. Then reconnect your computer to your own network and open http://cartpole.local.

Already set up? Update over Wi-Fi instead: drag the app image onto the board's dashboard.